PANBEX F3 EXTREME

PANBEX F3 – EXTREME is a pre-mixed cement fireproof powder mixture containing sorted hard fillers based on non-oxidizing metals, special cements, and compatible chemical ingredients. It is used to build an extremely resistant surface of concrete monolithic floors. Immediately after the usual treatment of the supporting slab concrete, pour PANBEX F3 EXTREME onto the freshly laid concrete mix.

Smooth repeatedly in order to obtain a highly-resistant and smooth, naturally anti-skid surface. Such a treading layer provides increased resistance against fat and oil penetration. Floors with the PANBEX F3 EXTREME surface finish are used in storage areas, factory workshops, wholesaling, and anywhere where a durable flooring system with an extremely durable surface is required.

SPECIAL CHARACTERISTICS

• extreme operational load resistance
• dust-free
• reasonable price
• fast application
• quaranteed quality – production outside of the construction site
• no maintenance required

QUALITY REQUIREMENTS

To obtain a comprehensive high-quality floor, cooperation between the project designer, the investor and the building contractor is vital. Below are the aspects each of them influences:

INVESTOR:

1. Correct specification of the type of facility operation
2. Requirements for special loads (equipment installation, etc.)
3. Determination of the mechanical, chemical, and thermal influences (vibration, pulsation, local overload, extreme fatigue of selected corridors, etc.)

PROJECT DESIGNER:

1. Structural design of the supporting slab while considering all of the following factors:
- properties of the foundation layer (geological survey)
- character of the specified load
- expansion joints
2. Selection of an adequate treading layer

BUILDING CONTRACTOR:

1. Verification of the data concerning the quality of the foundation and the concrete
2. Adherence to the concreting technology (boarding, compaction, placement of conventional reinforcement, required flatness...)
3. Ensuring a clean working environment (within a single work cycle, the concreting process is followed immediately by the final finish of the treading layer)
4. Evenness of the filling (preparation of the correct amount per relevant area)
5. Determination of the start of each technological operation
6. Experience of the roto-trowel personnel
7. Carefulness during the manual finishing of details (edges of working areas, column outlines, etc.)
8. Securing the floor surface against the rapid evaporation of water from the surface of a freshly laid slab with a filling
9. Correct selection of location and design of joints, attention to details – respecting the designer’s materials (change in the thickness of the supporting slab, area around the foundation footing, passages, thresholds, etc.)

TECHNICAL DATA